- Application Types
- Bulk deuterium treatment for optical fibre production
- Deuterium annealing of semiconductor devices
- Production-scale deuterated OLED material synthesis
- Continuous or pulsed feed for fusion and neutron sources
- Deuterated internal standards for LC-MS and NMR
- Deuterium arc lamps for UV-Vis and HPLC detectors
DIHYDRO50LS2
Deuterium Generator, Floor Standing
Leman Instruments designed the DIHYDRO50LS2 to bring the same ultra-high-purity deuterium (D2) process to production flow – built to sit in a production cell, not only a laboratory.
Heavy water is separated by membrane technology without any caustic solution, then dried and purified through two permeation stages down to a dew point of -50°C.
D2 is delivered at a chemical purity above 99.9995% (maximum hydrocarbon content 0.1 ppm) and an isotopic purity that depends on the heavy water supplied – five times the flow of the DIHYDRO50LS, at the same purity. Fed from an external heavy water reservoir, each kilogram of heavy water generates about 1,000 L of deuterium.
The DIHYDRO50LS2 delivers up to 5 NL/min, from a floor casing on castors.
Features
- Rapid return on investment. No cylinder rental fee, no deliveries.
- D2 available 24/7 at constant purity from heavy water and electricity alone.
- No consumables beyond the heavy water itself. No caustic solution in the process.
- Low stored D2 volume: the gas is made as it is used, not stockpiled under pressure.
- Internal leak test, automatic shut-down, over-pressure valve, current, water-quality and temperature monitoring.
- Two potential-free relay contacts for integration into a production line’s control system.
Gas
Models | DIHYDRO50LS2 |
Max outflow @1013 hPa / 20°C | DIHYDRO50LS2 : 5 NL/min |
Output purity |
|
Dew point | -50°C |
Outlet pressure | From 0.5 to 10 bar (7 to 145 psig) |
Site & Installation
Water source | External heavy water reservoir |
Water consumption | 1 kg of heavy water generates approx. 1,000 L of D2 |
Inlet / outlet fittings | Stainless steel 1/4″ OD |
Power supply | Automatic switching from 90 to 260 VAC, 47 to 63 Hz |
Power consumption | Maximum 2,000W |
Ambient temperature | +5 to +35°C, non-condensing |
Manual control | Through a 7″ TFT-LCD colour display with a touchpad. Intuitive navigation by menus and sub-menus. |
Remote control | 2 relay I/O – RS485 Mod-Bus – USB – Ethernet |
Safety |
|
Dimensions & Weight
Dimensions cm / in |
|
Net weight | 80 kg / 176 lbs |
Format | Floor-standing casing on castors |